Introduction:
FD-625VT IP Mesh Radios can be combined in a fluid self-forming, self-healing mesh network containing up to 32 nodes.
The entire mesh can operate in bandwidth from 1.4kHz to 20MHz, employing IFLY unique COFDM modulation scheme and LTE technology protocol with very high sensitivity, which make its performance very stable in nlos enviornment. Multiple Input Multiple Output (MIMO) technology transmits two way UDP/TCPIP data and UART control data.
Features:
➢Anti-interference: Automatically frequency hopping
➢Long Range: Up to 20watts RF Power to achive nlos 10km-50km ground to ground
➢Software: Visualizedreal commanding and dispatching software to real-time audio, video and data dispatching and management
➢UART Port for accessing sensors and control data
➢IP Interface as standard for easy connection of cameras and data
➢Easy control of cameras for PTZ
➢IP Mesh capability
➢Automatic Adaptive modulation
➢Built in wifi module for Management software wireless access to
GENERAL | MECHANICAL | ||
TECHNOLOGY | MESH based on TD-LTE Technology Standard | TEMPERATURE | -20º to +55ºC |
ENCRYPTION | ZUC/SNOW3G/AES(128/256) OptionalLayer- 2 Encryption | DIMENSIONS | 300×250×80mm |
DATA RATE | 30Mbps(Uplink+downlink) | WEIGHT | 8KG |
SENSITIVITY | 10MHz/-103dBm | MATERIAL | Anodized Aluminum |
RANGE | 10km-50km(Ground to ground) | MOUNTING | Vehicle- mounted |
NODE | 32 | POWER INPUT | DC28V |
MODULATION | QPSK, 16QAM, 64QAM | POWER CONSUMPTION | 120W |
MIMO | 2X2 MIMO | INTERFACE | |
ANTI-JAMMING | Automatically frequency hopping | RF | 2xN Type Connector |
RF POWER | 20Watts | ETHERNET | RJ45 |
LATENCY | One Hop Transmission≤30ms | POWER INPUT | 1*DC Input |
FREQUENCY | TTL DATA | 1*UART | |
1.4Ghz | 1427.9-1447.9MHz | DEBUG | 1*USB |
800Mhz | 806-826 MHz | ||
COMUART | |||
Electrical Level | 3.3V and compatible with 2.85V | ||
Control Data | TTL | ||
Baud rate | 115200 | ||
Transmission Mode | Pass-through mode | ||
Priority Level | Higher priority than the network port When the signal transmission is crowed, the control data will be transmitted in priority | ||
Note: 1. The data transmitting and receiving is broadcast in the network. After successful networking, each FD-625VT node can receive serial data. 2. If you want to distinguish between sending, receiving and control, you need to define the format. |
IFLY MESH solutions are capable of being set up and maintained autonomously, so personnel can focus on missions at hand as opposed to troubleshooting connectivity problems.
Emergency Ad-hoc Network Solution Portable Emergency Command System Drone Video Transmitters 5km UAV Video Transmitter 10km Drone Video Transmitter 50km Drone Video Transmitter 100km Airborne Video Downlink NLOS Wireless Video Transmitter PtMP Wireless Video Transmitter Wireless MESH Network