Frequency Option ➢ 800Mhz: 806-826Mhz ➢ 1.4Ghz: 1428~1448 MHz |
| ➢ Video Input Interface: HDMI and Ethernet ➢ Both 1400Mhz and 800Mhz have penetrate ability for barriers ➢ 1* Serial Ports: Bi-directional Data Transmission ➢ 2* Antennas: Dual Tx antenna and Dual Rx antenna ➢ 3*100Mbps Ethernet port support TCP/UDP ➢ 1/4 inch screw hole on Tx for fixing on UAV ➢ Latency less than 50ms ➢ H.264 Video Compression ➢ Baud Rate: 115200bps |
| ➢ Support MAVLINK TELEMETRY ➢ Support 2T 2R ➢ NLOS transmission with 800Mhz and 1.4Ghz ➢ Working Temperature: :-40 ~+ 85℃ ➢ CNC technology double aluminum alloy housings featured, good impact resistance and heat dissipation ➢ Conductive anodizing craft improves the integrity of RF signals |
Specifications
| Frequency | 800Mhz | 806~826 MHz |
| 1.4Ghz | 1428~1448 MHz | |
| Bandwidth | 4MHz | |
| RF Power | 0.4Watt (Bi-Amp, 0.4watt Peak Power of each power amplifier) | |
| Antenna Gain | 800Mhz TX:Omni antenna 25cm 2dbi | 1.4Ghz TX:Omni antenna 35cm 3.5dbi |
| Transmit Range | 800Mhz: 7km 1400Mhz: 8km | |
| Transmit Rate | 3Mbps (Video Stream, Ethernet Signal and serial data share) | |
| The best video stream: 2.5Mbps | ||
| Baud Rate | 115200bps(Adjustable) | |
| Rx Sensitivity | -104dbm@4Mhz | |
| Fault Tolerance Algorithm | Wireless baseband FEC forward error correction | |
| End to End Latency | 50-80ms for 1080P60/720P60 video encoding and decoding | |
| Link Rebuild Time | <1s | |
| Modulation | Uplink QNSK/Downlink QNSK | |
| Encryption | AES128 | |
| Start Time | 15s | |
| Power | DC-12V (7～18V) | |
| Interface | Interfaces on Tx and Rx are same | |
| Video input/Output: Ethernet×3 | ||
| Power Input Interface×1 | ||
| Antenna Interface: SMA×2 | ||
| Serial×1: TTL(±3.3V) | ||
| Indicators | Power | |
| Ethernet Status Indicator | ||
| Wireless Connection Setup Indicator x 3 | ||
| Power Consumption | Tx: 4W(Max) | |
| Rx: 3W | ||
| Temperature | Working: -40 ~+ 85℃ | |
| Storage: -55 ~+100℃ | ||
| Dimension | Tx/Rx: 57 x 55.5 x 15.7 mm | |
| Weight | Tx/Rx: 65g | |
| Metal Case Design | CNC Technology | |
| Conductive anodizing craft | ||
| Double Aluminum Alloy Shell | ||
Emergency Ad-hoc Network Solution Portable Emergency Command System Drone Video Transmitters 5km UAV Video Transmitter 10km Drone Video Transmitter 50km Drone Video Transmitter 100km Airborne Video Downlink NLOS Wireless Video Transmitter PtMP Wireless Video Transmitter Wireless MESH Network